This commit hacks in a bug fix for handling look-around across multiple
lines. The main problem is that by the time the matching lines are sent
to the printer, the surrounding context---which some look-behind or
look-ahead might have matched---could have been dropped if it wasn't
part of the set of matching lines. Therefore, when the printer re-runs
the regex engine in some cases (to do replacements, color matches, etc
etc), it won't be guaranteed to see the same matches that the searcher
found.
Overall, this is a giant clusterfuck and suggests that the way I divided
the abstraction boundary between the printer and the searcher is just
wrong. It's likely that the searcher needs to handle more of the work of
matching and pass that info on to the printer. The tricky part is that
this additional work isn't always needed. Ultimately, this means a
serious re-design of the interface between searching and printing. Sigh.
The way this fix works is to smuggle the underlying buffer used by the
searcher through into the printer. Since these bugs only impact
multi-line search (otherwise, searches are only limited to matches
across a single line), and since multi-line search always requires
having the entire file contents in a single contiguous slice (memory
mapped or on the heap), it follows that the buffer we pass through when
we need it is, in fact, the entire haystack. So this commit refactors
the printer's regex searching to use that buffer instead of the intended
bundle of bytes containing just the relevant matching portions of that
same buffer.
There is one last little hiccup: PCRE2 doesn't seem to have a way to
specify an ending position for a search. So when we re-run the search to
find matches, we can't say, "but don't search past here." Since the
buffer is likely to contain the entire file, we really cannot do
anything here other than specify a fixed upper bound on the number of
bytes to search. So if look-ahead goes more than N bytes beyond the
match, this code will break by simply being unable to find the match. In
practice, this is probably pretty rare. I believe that if we did a
better fix for this bug by fixing the interfaces, then we'd probably try
to have PCRE2 find the pertinent matches up front so that it never needs
to re-discover them.
Fixes#1412
This also replaces '--all' in Cargo commands with '--workspace'. The
former has apparently been deprecated.
We also fix a couple warnings that this new step detected.
Closes#1848
This fixes a bug where using \A or (?-m)^ in combination with
-U/--multiline would permit matches that aren't anchored to the
beginning of the file. The underlying cause was an optimization that
occurred when mmaps couldn't be used. Namely, ripgrep tries to still
read the input incrementally if it knows the pattern can't match through
a new line. But the detection logic was flawed, since it didn't account
for line anchors. This commit fixes that.
Fixes#1878, Fixes#1879
In a prior commit, we fixed a performance problem with the -w flag by
doing a little extra work to extract literals. It turns out that using
literals in this case when the -w flag is NOT used results in a
performance regression. The reasoning is that we end up using a "fast"
regex as a prefilter when the regex engine itself uses its own
equivalent prefilter, so ripgrep ends up redoing a fair amount of work.
Instead, we only do this extra work when we know the -w flag is enabled.
If a literal is entirely whitespace, then it's quite likely that it is
very common. So when that case occurs, just don't do (inner) literal
optimizations at all.
The regex engine may still make sub-optimal decisions here, but that's a
problem for another day.
Fixes#1087
The top-level listing was just getting a bit too long for my taste. So
put all of the code in one directory and shrink the large top-level mess
to a small top-level mess.
NOTE: This commit only contains renames. The subsequent commit will
actually make ripgrep build again. We do it this way with the naive hope
that this will make it easier for git history to track the renames.
Sigh.
