In order to implement --count-matches, we simply re-execute the regex on
the spans reported by the searcher. The spans always correspond to the
lines that participated in the match. This is the correct thing to do,
except when the regex contains look-ahead (or look-behind).
In particular, the look-around permits the regex's match success to
depends on an arbitrary point before or after the lines actually
reported as participating in the match. Since only the matched lines are
reported to the printer, it is possible for subsequent searching on
those lines to fail.
A true fix for this would somehow make the total span available to the
printer. But that seems tricky since it isn't always available. For
PCRE2's case in multiline mode, it is available because we force it to
be so for correctness.
For now, we simply detect this corner case heuristically. If the match
count is zero, then it necessarily means there is some kind of
look-around that isn't matching. So we set the match count to 1. This is
probably incorrect in some cases, although my brain can't quite come up
with a concrete example. Nevertheless, this is strictly better than the
status quo.
Fixes#1573
The top-level listing was just getting a bit too long for my taste. So
put all of the code in one directory and shrink the large top-level mess
to a small top-level mess.
NOTE: This commit only contains renames. The subsequent commit will
actually make ripgrep build again. We do it this way with the naive hope
that this will make it easier for git history to track the renames.
Sigh.
