Avoids resampling and channel mixing. This only tests the behavior
with respect to input and output audio rather than also testing changes
to the encoder or muxer that do not affect the resulting decoded output.
Avoids resampling and channel mixing. This only tests the behavior
with respect to input and output audio rather than also testing changes
to the encoder or muxer that do not affect the resulting decoded output.
This will allow decoding to md5 and doing a diff comparison to a reference
checksum instead of a fuzzy stddev or oneoff comparison.
Signed-off-by: Mans Rullgard <mans@mansr.com>
The output format is not always the same as the file extension,
which is sometimes required for correct probing. We can avoid
probing by specifying the format since it is already known.
This way we don't require a clearly defined corresponding input stream.
The result for the xwd test changes because rgb24 is now chosen instead
of bgra.
If either input or output layout is known and the channel counts match,
use the known layout for both. Otherwise choose the default layout based on
av_get_default_channel_layout().
Changed some FATE references due to some WAVE files now having a non-zero
channel mask.
This allows for testing floating-point audio encoders across different
platforms where exact comparisons are unreliable due to float rounding
differences.
Also, do not give AVCodecContext.frame_size priority for muxing.
Updated 2 FATE references:
dxa-feeble - adds 1 audio frame that is still within 2 seconds as specified
by -t 2 in the FATE test
wmv8-drm-nodec - durations are not needed. previously they were estimated
using the packet size and average bit rate.
It is unnecessary. Also, for some codecs we're reading more than 1 frame per
packet. Instead we use a private context variable to calculate the bit rate,
stream duration, and packet durations.
Updated FATE seek test, which has slightly different timestamps due to a
more accurate bit rate calculation.
Split off packet parsing into a separate function. Parse full packets at
once and store them in a queue, eliminating the need for tracking
parsing state in AVStream.
The horrible unreadable loop in read_frame_internal() now isn't weirdly
ordered and doesn't contain evil gotos, so it should be much easier to
understand.
compute_pkt_fields() now invents slightly different timestamps for two
raw vc1 tests, due to has_b_frames being set a bit later. They shouldn't
be more wrong (or right) than previous ones.
We need to set ms_stereo in encode_init() in order to avoid incorrectly
encoding the first frame as non-m/s while flagging it as m/s. Fixes an
uncomfortable pop in the left channel at the start of playback.
CC:libav-stable@libav.org
Fixes timestamp calculation.
The FATE reference is updated because timestamp calculations are now more
accurate. Previous timestamps were based on average bit rate.
This fixes clipping if the encoder input used the full 16 bit
input range (samples with a magnitude below 16383 worked fine).
The filtered subband samples should be 15 bit maximum, while
the code earlier produced them scaled to 16 bit.
This makes the decoder output have double the magnitude
compared to before.
The spec reference samples doesn't test the QMF at all, which
was why this part slipped past initially.
Signed-off-by: Martin Storsjö <martin@martin.st>
The container has no timestamps and the framerate isn't stored in the
data either.
The decoder sets codec timebase to experimentally found value 1/15. Do
the same for the demuxer too, it should at least be better than the
default 1/90000.
