Current code compares the desired recording time with InputStream.pts,
which has a very unclear meaning. Change the code to use actual
timestamps of the frames passed to the encoder.
In several tests, one less frame is encoded, which is more correct.
In the idroq test one more frame is encoded, which is again more
correct.
Behavior with stream copy should be unchanged.
This makes the AC3 encoder use the shared fixed-point MDCT rather
than its own implementation. The checksum changes are due to
different rounding in the MDCT.
Signed-off-by: Mans Rullgard <mans@mansr.com>
This increases the accuracy of coefficients, leading to improved quality.
Rescaling of the coefficients to full 25-bit accuracy is done rather than
offsetting the exponent values. This requires coefficient scaling to be done
before determining the rematrixing strategy. Also, the rematrixing strategy
calculation must use 64-bit math to prevent overflow due to the higher
precision coefficients.
This is to match the value in every (E-)AC-3 file from commercial sources.
It has a negligible effect on audio quality.
Signed-off-by: Mans Rullgard <mans@mansr.com>
This patch changes the exponent difference threshold in the exponent
strategy decision function of the AC-3 encoder. I tested lowering in
increments of 100. From 1000 down to 500 generally increased in quality
with each step, but 400 was generally much worse.
Signed-off-by: Mans Rullgard <mans@mansr.com>
This gives slightly better quality in PEAQ tests.
Code 3 gives a dBpb value of 2816 = -132dB (128 psd units = -6dB), which
corresponds to 22 bits. Since the exponents have an offset applied, the
16-bit source looks like 24-bit source to the bit allocation routine.
So using dBpb code=3 is a closer match to the exponent range.
Regression test refs updated for acodec-ac3, lavf-rm, and seek-ac3_rm.
Originally committed as revision 26144 to svn://svn.ffmpeg.org/ffmpeg/trunk
This avoids a 16-bit overflow in mdct512() due to a -32768 value in costab.
References updated for acodec-ac3, lavf-rm, and seek-ac3_rm tests.
Thanks to Måns Rullgård for finding the bug.
Originally committed as revision 26071 to svn://svn.ffmpeg.org/ffmpeg/trunk
With this change, the output is checked immediately after each test
has run. This means commands like "make regtest-mpeg2" can now be
used to run a single test and get meaningful results.
By default, make will abort if any test fails. To run all tests
regardless, use make -k.
Originally committed as revision 21254 to svn://svn.ffmpeg.org/ffmpeg/trunk
