This fixes segfault caused by 3d3cf6745e
when SingleChannelElement.ret was renamed to SingleChannelElement.ret_buf.
Signed-off-by: Justin Ruggles <justin.ruggles@gmail.com>
Scaling the denominator instead of the numerator if it is too large
loses precision. Fixes an assert caused by a negative frame duration in
the fuzzed sample nasa-8s2.ts_s202310.
CC: libav-stable@libav.org
Dropping frames is undesirable but that is the only way by which the
decoder could return to low delay mode. Instead emit a warning and
continue with delayed frames.
Fixes a crash in fuzzed sample nasa-8s2.ts_s20033 caused by a larger
than expected has_b_frames value. Low delay keeps getting re-enabled
from a presumely broken SPS.
CC: libav-stable@libav.org
The qpel functions referenced here are not related to h264 and should
thus never have been under CONFIG_H264QPEL.
Signed-off-by: Mans Rullgard <mans@mansr.com>
Signed-off-by: Diego Biurrun <diego@biurrun.de>
Preventing the use of discouraged or 'insecure' external functions
through defines in an internal header is not a good solution. The
header is not guaranteed to be included universally which makes
overlooking bad use of said functions during review more likely.
There are cases were those functions either are the most straight
forward solution or even have to be used. Using malloc or free is
required if the allocation or release is done by other libraries.
The only CPUs that have 3dnow and don't have mmxext are 12 years old.
Moreover, AMD has dropped 3dnow extensions from newer CPUs.
Signed-off-by: Diego Biurrun <diego@biurrun.de>
It is handled separately from other types because it uses stream
specifiers and currently that triggers an assert in SET_DICT.
CC:libav-stable@libav.org
'k', 'M', and 'G' are SI (unit) prefixes or metric prefixes,
not 'number postfixes'. Also, the statement regarding binary
prefixes ("powers of 2 are used instead of powers of 10")
might be misinterpreted (1 kB = 10^3 B, but 1 KiB != 2^3 B).
Signed-off-by: Diego Biurrun <diego@biurrun.de>
GCC does not appear to have a -march= string for Westmere, which is a
bit surprising as it has a few more instructions than a Nehalem, but
a few less than a Sandy Bridge.
Signed-off-by: Diego Biurrun <diego@biurrun.de>
- Add special cases for offsets of 2, 3, or 4 bytes. This means the
offset is always >4 in the generic case, allowing 32-bit copies to
be used there.
- Don't use memcpy() for sizes less than 16 bytes.
Signed-off-by: Mans Rullgard <mans@mansr.com>
This is useful for debugging. Dependencies for these files are not
generated due to limitations in many compilers.
Signed-off-by: Mans Rullgard <mans@mansr.com>
Current code would incorrectly process e.g. 'ff 00 ff 00 ff' to
'ff ff ff', while it should be 'ff ff 00 ff'.
Fixes Bug 395.
CC: libav-stable@libav.org
The vertical offset mask 0x07 is suspicious.
v_off = FFMIN(data[2] & 0x07, CDG_BORDER_HEIGHT - 1);
Note that v_off is up to 11 (CDG_BORDER_HEIGHT - 1), the correct mask
should be 0x0F.
Signed-off-by: Xi Wang <xi.wang@gmail.com>
Signed-off-by: Anton Khirnov <anton@khirnov.net>
The following error handling is broken due to signedness.
int file_size;
uint32_t tag_bytes;
int64_t tag_start;
...
tag_start = file_size - tag_bytes - APE_TAG_FOOTER_BYTES;
if (tag_start < 0) { ... }
Note that tag_bytes is unsigned, which makes the right-hand side of
`tag_start = ...' unsigned, too. The 32-bit unsigned value is then
zero-extended to 64 bits. Therefore, tag_start must be non-negative,
and the check (tag_start < 0) is always false, which breaks the error
handling. This patch fixes the check.
Signed-off-by: Xi Wang <xi.wang@gmail.com>
Signed-off-by: Anton Khirnov <anton@khirnov.net>
The sample count is decremented by the DECODE() macro and needs to be reset
in each loop iteration. Also, DECODE() increments the src pointer so that does
not need to be done separately.
This is (erroneously) required to enable various things in the
newlib headers. As cygwin uses newlib, it is covered by this.
Signed-off-by: Mans Rullgard <mans@mansr.com>
If there are any samples remaining in the output fifo from previous conversion
calls, we have to output those samples first instead of doing direct output
of the current samples.
A bug in tail call optimisation in gcc 4.3 and later on parisc causes
numerous tests to fail. Disabling this optimisation gives a working
build. See http://gcc.gnu.org/bugzilla/show_bug.cgi?id=55023
Signed-off-by: Mans Rullgard <mans@mansr.com>
SWS_CPU_CAPS are deprecated and slated to removed with libswscale major
version 3. No need to provide a SWS_CPU_CAPS_MMX2 as backward
compatibility define under the same explicit condition.
